Goal: The goal is to improve the industry's ability to quantitatively estimate reservoir parameters from geophysical data, thereby reducing the cost and improving the efficiency of oil and gas exploration efforts.
Objectives: The objectives are to: (A) investigate the feasibility of simultaneously inverting different types of geophysical data linked through a rock physics model to produce a single self-consistent earth model parameterized by hydrologic parameters (porosity, saturations, etc.) rather than geophysical measurements, and if such an inversion is feasible, to (B) develop specific algorithms to use land and marine geophysical data to arrive at these parameters.
Lawrence Berkeley National Laboratory (LBNL) ? project management and all research products
In the past, application of complementary data sets for identification of fluid properties has centered on an iterative, interpreter-driven process, where results from one data set were used to guide and constrain the interpretation of another. While this technique produces useful results, it is limited by a high degree of subjectivity and lacks the statistical measures needed to quantify uncertainties in the fluid properties of the reservoir. In this project, researchers will interpret complementary data sets by joint inversion/imaging, where fluid properties are calculated directly from the data by the mathematical process of inversion.
Researchers will consider various forms of geophysical data while designing the inversion codes, however, the focus of the project is on seismic, gravity and EM data acquired in the marine environment. The objective of the algorithm development is to create general codes capable of incorporating an appropriate petrophysical model to estimate reservoir fluid properties.
Thus far in the project, researchers have investigated using only seismic travel-time and event move-out data (eliminating the need to estimate the source waveform and source and receiver coupling). Full waveform seismic data will be considered as the project continues.
Current Status and Remaining Tasks: Remaining tasks include evaluation of the merits and costs of using full waveform seismic inversion as compared to industry standard AVO inversion as the seismic component in an advanced joint seismic-EM inversion code. LBNL will develop a prototype 2-D cell-based full waveform seismic inversion code for this comparison.
Project Start: July 1, 2002
Project End: June 30, 2005
DOE Contribution: $358,000
Performer Contribution: $0
NETL ? John D. Rogers (firstname.lastname@example.org or 304-285-4880)
LBNL ? Gregory A. Newman (email@example.com 510-486-6887)